This rotary hand pump is ideal for applications where gravity feed is not possible. Pumps approximately 7-1/2 gallons per minute. Works with both the GW14 and the GW29.
Description: RP90 Rotary Hand Pump
Outlet Valve Plate Assembly for Gusher 10 Pump
Description: Outlet Valve Plate Assembly, (suitable for the mark 3 only), Fits: Gusher 10
Overhaul Kit for Crown Cd Head
Description: Overhaul Kit, Centrifugal Discharge Series
Ph/PHE Overhaul Kit Pre 6/79
Description: PH & PHE Repair Kit
PHII/PHEII Overhaul Kit After 6/92
Description: PHII & PHEII Cartridge Seal (after 6/92)
PHII/PHEII Overhaul Kit Pre 6/92
Description: PHII & PHEII Repair Kit
Piston Rod Yoke for PHII Heads
Description: Plastic Piston Rod Yoke
020303: Has 3 recessed to holes for flush fit to boat's transom or exterior, allowing water to drain when boat is trailered.020304: Made of tough Celcon to fit our transom drain tube or to replace the brass garber plug. Plug has screwdriver slot and rubber o-ring to seal water tight.
Description: Plug & O-Ring Only, Pack: 5
Pulley & clutch assembly for clutch pump.
Description: Electro-magnetic clutch, 12V 2xA pulley double groove
Description: Electro-magnetic clutch, 12V 1xB pulley single groove
Pump Assembly Complete for PHII
Description: PHII Pump & Base Assembly
Pump Assy for New Crown Cd Head
Description: Intake Pump Assembly, Complete
PWC Pump On/Off Switch
Description: On/Off Switch
Raw Water Kit For Prem Plus
Description: Raw Water Kit, includes pump & EasyFit hardware only, Volts: 12
Repair Kit For MS1200
Description: Repair Kit, Fits: MS1200
Description: Replacement Plug
"Molded nylon. Drain tube 1-1/8"."
Description: Replacement Plug , Pkg.: Bulk
Description: Replacement Plug, Pkg.: Card, Pack: 2
"Replacement New Style Handset, 1/2" Hose Threads"
Description: Replacement Handset, Fits: "New Style w/ 1/2" Hose Threads"
"Molded nylon. Designed to fit securely in a 1" hole without the use of fasteners. The ridges on the body of the drain plug are designed to keep the plug in place. Sealant should be applied prior to installation to make a watertight seal."
Description: Replacement Plug & Gasket, Pack: 30