Outdrives and Accessories - Nose Cones

MerCruiser High Speed Bravo Nose Cone 1990-newer
Your Price:
$129.99

MerCruiser High Speed Bravo Nose Cone 1990-newer

620-11250

 MerCruiser High Speed Bravo 1990-newer

Nose Cones are recommended on boats running in the 80 MPH range to enhance propeller efficiency and eliminate blow out.  Propeller blow out is encountered when water separates from the gear case to the point where thedistance is equal to or greater than the radius of the propeller MPH gains can be 2 to 6 MPH with the right propeller set up.  Bravo castings are for 1990 and later.  They come in either standard or low water pickup designs. Low water cones are used when running a high-X-dimension on high performance applications.  All nose cone castings are 6063-T6 and molded to a glove like fit.  This enables it to be installed with epoxy putty.  Low water nose cones require a water passage to be machined in the lower unit (no external hoses). Does not fit Bravo 2 or 3 drives.

High Water Flow Capacity: Allow surface Piercing props (choppers, cleaver style) to be run at maximum height for top speed and all out performance, while maintaining proper cooling to engine.

NOTE: These nose cones are rough castings that require body filler, finishing and smoothing. Epoxy is required to install.

TRS Nose Cone (Does Not come w/ Epoxy)
Your Price:
$164.99

TRS Nose Cone (Does Not come w/ Epoxy)

711-HC-MC2A

TRS Nose Cone (Does Not come w/ Epoxy)

This is a nose cone for a TRS drive. It does not come with epoxy